Heavy duty Fleece Jackets

Protect your plants from severe winter weather by simply pulling the specially designed fleece jacket over your plant for partial protection. Ideal for semi hardy palms, cordylines, and brugmansias in mild areas during   extra cold nights. The jackets are made of a heavy material giving significantly more frost protection than normal Fleece.
• Protects your plant from frost & wind
• Drawstring ends for tying round base or container
• Extra strong material 70g/sqm

Control of insect pests is an essential part of successful plant cultivation. It is especially important indoors, in conservatories or in greenhouses where they favour the conditions and populations can explode. Until recently the only insecticide we had to control spider mite effectively was Dynamec but unfortunately this was very expensive and only available through the trade . Killermite concentrate contains the same active ingredient Abamectin making it highly effective against spider mite as well as Western Flower Thrips and Leaf Miner. This formulation is intended for ornamental plants under glass and is licenced for professional users. We offer 25ml of concentrate in a sample bottle for growers that would like to clear spider mite infestations on Conservatory ornamentals including Brugmansia and Banana plants at a sensible cost. Diluted at a rate of 0.5ml per litre and plants sprayed both sides of infected leaves. I have been using Abamectin for many years and so far not had any adverse reactions on tender conservatory plants.

Recent customer comment "I ordered some Killermite earlier in the week - it arrived this morning. I made the solution up immediately and sprayed the whole of the greenhouse (15x10ft). Until today I have had 5 years of sporadic Spidermite outbreaks (recently there has been a really serious problem). I've just been back out to the greenhouse - every trace of the Spidermites have vanished. This is the best purchase I have ever made for the greenhouse - just wish I had discovered sooner. I cannot recommend highly enough!!!

Based on many years of experience you normally only need small seed containers for initial germination in a propagator. For growing plants in larger quantities of course normal half or full size seed trays are ideal but for smaller quantities try using these clear polypropylene containers.

• A normal full size 38cm seed tray will house 8 of these containers maximising your heated space.
• They have the advantage of being able to see any initial roots through the clear sides and base.
• They can be removed individually as soon as plants are too large, ready for pricking out.
• Each container can be easily turned around if the seedlings are bending one way towards the light.
• The low height is sufficient for initial root development but maximises growing height within a propagator lid.
• Size 108mm L x 82mm W x 50mm H
• Microwaveable so easily cleaned in very hot water
• Recyclable polypropylene material but useful for repeated use if cleaned thoroughly.
• Stackable so easily stored away when not in use 
• NOTE these are supplied WITHOUT drainage holes - please drill 4 off 5mm to 10mm holes in the base or using a sharp pointed knife pierce and twist 4 holes in the base for drainage.